Trim Or Frameless Installation - Valor 500FS Installer And Owner Manual

INSTALLER GUIDE
16. TRIM & FRAMELESS INSTALLATION
1. Trim
Place the four magnets supplied on the rear of the trim one into each corner. Ensure
they are laided flat against the surface of the trim. Offer the trim towards the fire, the
trim secures with the magnets to the outside metal return on the outer convector box.
Push the trim tight up to the fire ensuring that the magnets are fully incontact and
holding the trim in place.
2. Frameless
The frameless trim is pre fitted with screws securing it onto the outside face of the fire
with sealing tape along its base already sealing the frame to the convector box.
NOTE: During installation the additional length of foam seal is required to be fitted on
top of the sealing tape (Refer to section 11.3).
©
Page 36
GDC Group Ltd. SEPT 2016