Setting The Handset And Receiver Relationship (Rc); Checking The Ignition Operation (Rc) - Valor 500FS Installer And Owner Manual

WARNING: NEVER connect a 9-Volt battery directly to the cable of the remote
battery box. This connection is the only to be used to connect the reciever to the
remote control.
It is important that the wires from the battery box do not touch the underside of
the burner tray and that the battery box is positioned as far on the Left Hand
Side as possible and along the front to make access for replacement of
batteries as easy as possible.
10.3 Setting the handset and receiver
relationship.
The receiver will have to be set to learn
the handset / remote code. Do this as
below:
- Place the 'ON/OFF' switch to the '-' (On
position). This is on the right hand front of
the appliance.
- Press and hold the reset button on the
receiver until you hear two (2) acoustic
signals. After the second, longer acoustic
signal, release the reset button.
- Within the subsequent 20 seconds press the 'DOWN' button
on the handset until you hear an additional long signal
confirming the code is set
(Please inform the customer that this is a one time setting and
is NOT required when changing batteries in the handset or
battery box).
9.4 Checking the ignition operation.
Press and hold the 'ON' button until two short beeps
-
(acoustic signal) and a blinking series of lines confirms the
start sequence has begun; release button.
Continuing signals confirms the ignition is in progress. There
-
will be a slight delay and several sparks should be seen
between the electrode and pilot tip.
On sensing a flame is not present the burner unit will shut
-
off. If there are no sparks check the following:
Ensure that the electrode lead is connected to the terminal
-
at the base of the electrode.
If the above is correct, check for damage to the electrode
-
lead and that the batteries have been correctly fitted.
©
GDC Group Ltd. SEPT 2016
INSTALLER GUIDE
Reset button
Page 24