Fitting The Ceramic Fuel Effect; Firefront / Bottom Cover Installation - Valor 940 Installer And Owner Manual

13. FITTING THE CERAMIC FUEL EFFECT

The installer and owner guide for the ceramic fuel effect is supplied with the ceramic
fuel effect. It is important that the fitting guide for the ceramic fuel effect be placed
inside or attached to this guide and handed to the customer following completion of
the 'Final review' section.
Ensure that the fire is OFF. Open the isolating valve at the inlet 'T' connector and
replace the end cap. Light the fire, turn to the maximum output position and test
around the sealing screw for gas soundness with a suitable leak detection fluid.

14. FIREFRONT / BOTTOM COVER INSTALLATION

14.1 Adorn bottom front cover.
Place the bottom front cover in position below
the fascia bridge.
14.2 Visage fire front casting.
Fit the fire front casting to the fascia. Locate the
two screw heads at the rear top corners of the
firefront casting through the keyhole slots at the
inner sides of the fascia. If the screw heads do
not project enough or project too far, the screws
can be adjusted. Lower the casting so that it
rests on the hearth (See figure 42).
©
GDC Group Ltd. 2011
INSTALLER GUIDE
Page 35
Figure 41. Control bar and pivot
bracket (Shown with Adorn fascia)
Figure 42. Firefront casting (Casting
may differ from that shown).