Tires - Suzuki EN125-2A Service Manual

2-15 PERIODIC MAINTENANCE AND TUNE-UP PROCEDURES
Brake lining wear limit
This motorcycle is equipped with brake lining wear
limit indicator on rear brake. As shown in the
illustration at right, at the condition of normal
lining wear, an extended line from the index mark
on the brake camshaft should be within the range
embossed on the brake panel with the brake on. To
check wear of the brake lining, follow the steps
below.
Fist check if the brake system is properly
adjusted.
While operating the brake, check to see that the
extension line from the index mark is within the
range on the brake panel.
If the index mark is outside the range as shown
in the illustration at right, the brake shoe assy
should be replaced to ensure safe operation.

TIRES

Inspect initial 1 000 km and Every 4 000 km
TIRE
Inspect the tires for wear and damage; and check
the tire tread depth as shown. Replace a badly
worn or damaged tire. A tire with its tread worn
down to the limit (in terms of tread depth) must be
replaced.
TIRE TREAD DEPTH SERVICE LIMIT
Front
Rear
Check the tire pressure, and examine the valve for
evidence of air leakage.
TIRE PRESSURE
Cold inflation
Sold riding
tire pressure
kPa
Front 175
200
Rear
1.6 mm
1.6 mm
Normal riding
Dual riding
2 2
kg/cm kg/cm
kPa
1.75 175 1.75
2.00 225 2.25
The extension line of the index mark is within the range.
The extension line of the index mark is outside of the range.