Remove the rear wheel axle nut and remove
rear wheel axle;
Remove the chain from the large sprocket;
Remove the rear wheel;
Separate the rear wheel and drive sprocket;
REAR SPROCKET
Flatten the lock washer and screw out the
sprocket nuts;
Remove the sprocket hub and sprocket;
Remove the wheel bearings by using the
special tool in the following procedures.
Insert the adapter
After inserting the wedge bar
side, lock the wedge bar in the slit of the adapter.
Drive out the wheel bearing by knocking the
wedge bar.
Caution:
The removed bearing should be replaced.
Bearing remover
in to the wheel bearing.
from opposite
09941-50110
REAR WHEEL AND REAR BRAKE
2-2