Suzuki EN125-2A Service Manual page 80

GEAR SHIFTING CAM DRIVEN GEAR
When installing the gear shifting pawls into the
cam driven gear. The large shoulder
to the outside as shown.
Next, install cam guide and pawl lifter, Apply a
small quantity of THREAD LOCK "1342" to the
threaded parts of the securing screws.
THREAD LOCK
"1342"
GEAR SHIFTING SHAFT
Install the gear shifting shaft. Match the center
teeth of the gear on the shifting shaft with the
center teeth on the shifting driven gear as
shown.
NOTE:
After the cam driven gear, cam guide, gear
shifting shaft and neutral cam stopper have
been fitted, confirm that gear change is
normal while turning the countershaft and
driveshaft. If gear change is not obtained, it
means that assembly of gears or installation
of gear shifting fork is incorrect. If this is the
case, disassemble and trace the mistake.
PRIMARY DRIVE GEAR AND OIL PUMP
Fit key in the key slot on the crankshaft, and
install the primary drive gear.
must face
A
99000-32050
A
Top Top
4th 4th
3rd 3rd
2nd 2nd
N N
Low Low
ENGINE 3-48
A