First-Time Installation; Installing The Avaya 2050 Ip Softphone For The First Time - Avaya 1110 Fundamentals

First-time installation

During the first-time installation, the two IP address parameters entered either manually or
automatically, depending on the installation configuration. They are as follows:
• Static IP address assignment
• Partial DHCP

Installing the Avaya 2050 IP Softphone for the first time

Use Configuring an Avaya 2050 IP Softphone
Softphone for the first time.
Configuring an Avaya 2050 IP Softphone
1. Install the Voice Gateway Media Card. For more information, see Avaya Signaling
2. Configure a virtual loop on the Call Server, using LD 97.
3. Configure the Avaya 2050 IP Softphone using LD 11. At the prompt, enter the
4. Install the USB Headset Adapter. If you are using the mobile adapter, connect the
5. Connect the USB cable to the headset adapter and to one of the USB jacks on the
6. Install the Avaya 2050 IP Softphone.
IP Deskphones Fundamentals
Server IP Line Applications Fundamentals, NN43001-125.
For more information, see Avaya Software Input Output Reference-Administration,
NN43001-611.
following
REQ: new
TYPE: 2050PC
headset to the adapter. If you are using the desktop adapter, you must
a. Connect the coiled lower cord to the headset cord with the Quick
Disconnect connector. Ensure the Quick Disconnect connector is
securely fastened.
b. Connect the headset cord to the RJ9 jack on the adapter.
back of your PC or USB hub.
The first time the headset adapter is plugged in, a delay occurs while Windows
configures the device and locates the appropriate driver software . During the
installation, you are prompted to supply the original Windows CD-ROM so Windows
can locate the required drivers.
on page 165 to install an Avaya 2050 IP
First-time installation
February 2013 165