Avaya 1110 Fundamentals page 559

Use the following procedure to download the Node Locked license files keyed to each phone
by MAC address from the provisioning or TFTP server
Downloading a Node Locked license file
1. Configure the phone with a provisioning server IP address so it can access a
2. The IP Deskphone config file must include a [LICENSING] section to enable the IP
3. Place the IP Deskphone's license file on the provisioning server.
4. Start the provisioning server so the phone can retrieve the .cfg files when the server
If there is a newer version of the license file on the provisioning server, the newer version
downloads and overwrites the current file on the IP Deskphone. The IP Deskphone then
restarts to activate the new license.
Network Locked license file
If a Network Locked license file is to be used, the same license file can be installed on all
phones. In this case, the wildcard "*" should not be used in the FILENAME since the filename
is fixed and will not contain the MAC address of each phone.
IP Deskphones Fundamentals
provisioning server.
For more information about provisioning parameters on the IP Phone, see
Provisioning the IP Phones
Deskphone to download the licence file. Add a [LICENSING] section to the IP
Deskphone .cfg file.
Examples of IP Deskphone cfg files are 1120e.cfg, 1140e.cfg, 1165e.cfg, 1220.cfg,
or 1230.cfg.
The [LICENSING] section specifies a wild card filename which uses the IP
Deskphone MAC address as the filename with the ipctoken prefix and cfg suffix.
For example:
[FW]
DOWNLOAD_MODE AUTO
VERSION 0625C4E
PROTOCOL TFTP
FILENAME 1140es.bin
[LICENSING]
DOWNLOAD_MODE AUTO
VERSION 000001
FILENAME ipctoken*.cfg
The generated license file must be named ipctokenMAC.cfg, where MAC is the
12-character MAC address of the IP Phone. For example, for an IP Deskphone with
MAC address "000f1fd304f8", the license file must be
namedipctoken000f1fd304f8.cfg.
starts.
on page 443.
Licensing files
February 2013 559