Avaya 1110 Fundamentals page 300

Avaya 1165E IP Deskphone
5. Install the headset (optional). If you are installing a headset, plug the connector into
6. Install the Ethernet cable. Connect one end of the supplied Ethernet cable to the
7. Install the Ethernet cable connecting the PC to the phone (optional). If you are
300 IP Deskphones Fundamentals
Figure 61: Cable routing tracks
the RJ-9 headset jack on the back of the phone, and thread the headset cord along
with the handset cord through the channels in the stand, so that the headset cord
exits the channel marked with the headset symbol. See <cable routing tracks>.
back of your phone using the CAT5-e connector (LAN Ethernet port), and thread
the network cable through the channel.
connecting your PC through the phone, a second CAT5-e cable is required. Only
one cable is included with the Avaya 1165E IP Deskphone package. Connect one
end of the PC Ethernet cable to your phone using the CAT5-e (PC Ethernet port),
and thread it through the channel marked with the symbol. Connect the other end
to the LAN connector on the back of your PC.
The LAN Ethernet port supports Auto-Media Dependent Interface Crossover
(MDIX). Auto-MDIX is supported only when the Ethernet port is configured for
autonegotiation. The PC Port does not support Auto-MDIX.
Caution:
Damage to Equipment
Do not plug any device into your Avaya 1165E IP Deskphone Ethernet port other
than an IEEE 802.3 Ethernet network connection. The Avaya 1165E IP
Deskphone does not support multiple devices connected through the PC
Ethernet port.
Comments? infodev@avaya.com
February 2013