Minolta DEClaser 2200 Service Manual page 89

Table 3–4 (Cont.): Service Messages
Number
Message Description and Action
81 SERVICE A COMMAND or STATUS signal parity error is detected.
Swap the following components until the message clears:
1. Video control board
2. DC control board
82 SERVICE Bit 3 of the printer status bit is a 1.
Swap the following components until the message clears:
1. Video control board
2. DC control board
83 SERVICE Bit 7 of the printer status bit is a 1.
Swap the following components until the message clears:
1. Video control board
2. DC control board
84 SERVICE This is a timeout error. The video control board has failed to transmit one
page of video to the dc control board.
Swap the following components until the message clears:
1. Video control board
2. DC control board
85 SERVICE This is a timeout error. The
PRINT
signal.
Swap the following components until the message clears:
1. Video control board
2. DC control board
V SREQ
signal was not asserted after the
DEClaser 2200 Troubleshooting 3–23