Minolta DEClaser 2200 Service Manual page 72

Table 3–1: Operational Status Messages
Number
Message
00 READY
01 Test Print B
02 WARMING UP
03 RESET
04 TEST STOP
05 TEST PRINT A
06 FONT LIST
06–10
3–6 DEClaser 2200 Printer Service Guide
Description and Action
The printer is ready to print. If the On Line indicator is on, print
files can be sent from the host. If the On Line indicator is off, the
printer is in the offline ready mode. In the normal mode you can
print test sheets, enter the setup menus, or perform any offline
task.
The printer is generating and printing Test Print B. See
Section 2.3.3 for more information about Test Print B.
The printer is waiting for the fixing unit to reach operating
temperature. If the fixing unit fails to reach the correct operating
temperature, the 50 SERVICE message is displayed.
This message is displayed for about four seconds to confirm that
the reset function is completed. Pressing
function.
This message is displayed to show that the generation and printing
of a test pattern is stopping. The message is displayed while the
remaining paper is printed and ejected.
This message is displayed during the generation and printing of
Test Print A.
This message is displayed during the generation and printing of
the Font List.
Not used.
initiates the reset
Reset