Minolta DEClaser 2200 Service Manual page 51

Table 2–4 (Cont.): 2200 Setup, Feature, and Value Menus
Setup Feature
Level Level
LAYOUT offsetX
offsetY
The LOAD<– ROM factory values are in bold.
The equal (=) sign indicates the selected value. When you scroll into a value level, the selected
value is displayed first.
Value
Level Comment
When you select Manual, the display
prompts you to load a sheet of paper into
the manual feeder. When the manual feed
sensor detects the paper, the dc control
board activates the paper feed clutch
and feeds the paper into the registration
rollers.
NOTE: The Manual display text
and control panel indicator appear
only if the printer is in simplex
test mode.
The Option display text and indi-
cator appear only if the optional
envelope feeder is installed and
faceup stacking is selected.
n.n The X and Y offset features use the same
=0.0 value format. The selected value causes a
shift of the printed image on the page, in
the selected dimension:
• The X dimension shifts the image
from side to side by varying the start
of the beam on the OPC drum.
• The Y dimension shifts the image
from leading to trailing edge by
varying the timing of the registration
clutch solenoid.
Pressing
<
ments the displayed value by ±0.5. Each
0.5 change shifts the image by ±15 dots or
±0.05 in. (±1.27 mm).
The minimum value is 0.0, which corre-
sponds to the center of the sheet. The
maximum value is ±10, which would shift
the image about 1.0 inch in the selected X
or Y direction.
DEClaser 2200 Control Panel Operation
or increments or decre-
>
2–9