Table of Contents
Advertisement
Table 3–4 (Cont.): Service Messages
Number
Message
Description and Action
63 SERVICE
RAM errors were detected after power-up.
Swap the following components until the message clears:
1.
Video control board
2.
DC control board
64–67
Not used.
68 SERVICE
NVRAM errors were detected after printer power-up.
Swap the following components until the message clears:
1.
Video control board
2.
DC control board
69 SERVICE
A timeout error occurred because no status information was returned from
the expansion interface. To clear this error, you must power the printer off,
then on.
Swap the following components until the message clears:
1.
Video control board
2.
DC control board
70 SERVICE
Errors were detected in the expansion board RAM.
Swap the following components until the message clears:
1.
Video control board
2.
DC control board
71 SERVICE
Errors were detected in the S-CPU during power-up.
Swap the following components until the message clears:
1.
Video control board
2.
DC control board
DEClaser 2200 Troubleshooting
3–21
Advertisement
Table of Contents
