Minolta DEClaser 2200 Service Manual page 82

3.3.3 Functional Messages and Faults
Table 3–3 lists all status messages, explains the message, and provides
troubleshooting information if the message faults.
Table 3–3: Functional Messages
Number
Message
FE FONT REMOVAL
FF FONT FULL
20 PAGE FULL
21 COMPLEX DATA
22 LINE ERROR
3–16 DEClaser 2200 Printer Service Guide
Description and Action
A font cartridge was removed or inserted while the printer was
powered on. To clear this error, power the printer off, then on.
Always insert or remove a font cartridge while the printer is
powered off.
Swap the video control board if you cannot clear the error.
There is insufficient memory space for loading of an additional
font or there are too many downline loaded fonts. Memory can be
cleared by a software command from the host or by pressing
.
Reset
The host system is overflowing the page buffer memory.
Press , then
Error Skip On Line
page.
To avoid this error, delete unused character sets and use the full
paint mode. If this error occurs frequently, the customer can install
optional memory to increase available RAM.
The host system is loading the page buffer faster then the printer
can print. Press , then
Error Skip
next page.
Set the paint = full value from the initial setup menu.
The host is sending data when the printer is in the busy state. This
causes an overflow of the receive buffer memory. Press
then to continue. The overflow data does not print.
On Line
This error can occur when the customer powers up the printer
before powering up the attached host system.
If this error occurs frequently, check the data cable between the
host and printer and make sure the printer interface settings
match the settings of the host.
If you cannot clear this error, swap the video control board.
to print the overflow data on the next
to continue printing on the
On Line
,
Error Skip