Table of Contents
Advertisement
FIP NOTES: Figure 3–2 is a continuation of Figure 3–1. Turn to the start
FIP (Section 3.1) for general FIP information.
Figure 3–2: Power-Up Fault
Call site electrician to connect
or restore the ac power to the
wall outlet. Does the printer
blow the site power line
circuit breaker?
Yes
The problem is in one of
the following components:
Inspect the ac
line cord.
Replace the ac
inlet assembly.
Return to start on
FIP Figure 3-1.
3–4 DEClaser 2200 Printer Service Guide
Start
No printer response to power-up.
Is the ac power O.K. at
the wall plug?
Bad AC
Check/replace the power cord.
Does the problem still exist?
Is CB101 open
(is the button up)?
No
Yes
Reset CB101. Does
CB101 open again?
Yes
Swap the following components
to fix the problem:
Fixing unit
LVPSA
AC inlet assembly
O.K.
No
Is the LVPSA
fuse blown?
No
Yes
Replace the fuse.
Does the fuse blow again?
Yes
MLO-004921
Advertisement
Table of Contents
