Table of Contents
Advertisement
Table 3–4 (Cont.): Service Messages
Number
Message
Description and Action
52 SERVICE
The scanner motor is not up to speed. Check the scanner assembly electrical
connectors for good connections. Swap the following components until the
message clears:
1.
Scanner assembly
2.
DC control board
53–55
Not used.
56 SERVICE
The home position notch on the alignment cam was not detected by the home
position sensor. Do the following:
1.
Inspect the connector that connects the alignment guide drive assembly
to the wire harness of the duplex unit.
2.
Inspect the J214 connector to the dc control board.
3.
Swap the alignment guide drive assembly as shown in Section 4.40.
4.
Swap the dc control board.
57–59
Not used.
60 SERVICE
This is a direct memory access (DMA) error that occurs after you power up
the printer.
Swap the following components until the message clears:
1.
Video control board
2.
DC control board
61 SERVICE
A checksum error was detected in the program and font ROMs.
Swap the following components until the message clears:
1.
Video control board
2.
DC control board
62
Not used.
3–20 DEClaser 2200 Printer Service Guide
Advertisement
Table of Contents
