Table of Contents
Advertisement
CombiFlash® R
Installation Guide
f
4. Click OK to save the settings. The CombiFlash R
will send a test page to the printer.
After successfully printing a test page, the network printer
will be available for printing using the File>Print menu
command or through the Automatically Print Report at End of
Run feature described below.
4.1.3 Automatically Print Report at End of Run
If the CombiFlash R
network printer (Section 4.1.2), it may be configured to print a
report at the end of each run. The report includes the method
settings, chromatogram, and peak/tube collection information.
To enable this feature:
1. Select the Tools>Configuration menu command.
2. The Configuration window has two tabs. Select the
Instrument Configuration tab.
3. Select the "Automatically Print Report at End of Run"
option.
4. Click OK to save the setting.
4.2 Direct Connection
A direct connection supports communication between the
CombiFlash R
recommendations in Table 4-1.
This guide provides instructions for Windows 2000 (section
4.2.1), Windows XP (4.2.2), and Windows Vista (4.2.3). Refer to
the applicable section, then follow the instructions in section
4.2.4 to complete the direct connection.
Note
A direct connection requires a "crossover" CAT5 cable. Standard
CAT5 network cables will not work. You can purchase a crossover
cable locally or ask your Information Technology department to
assemble one. You can also order a crossover cable (part number
480-6545-02) from Teledyne Isco.
Note
These instructions assume that the system is using the factory-set
IP address of 192.168.1.51.
4-4
system can successfully print to a
f
system and a single PC that meets the
f
system
f
Advertisement
Table of Contents
