Table of Contents
Advertisement
CombiFlash® R
Installation Guide
f
• Is it possible to assign a static IP address based on the
MAC address of the instrument? (Administrators may
use this method to assign static addresses through
the DHCP server instead of directly on the
instrument, simplifying the management of static IP
addresses within the organization.)
Note
A label on the system's back panel lists its MAC Address. You also
can find the MAC Address on the Help>About PeakTrak window.
• Can the DHCP server support an infinite lease for the
instrument?
• Can the DHCP server automatically update the DNS
records after the IP address is given to the
instrument?
If you select "DHCP," enter a unique Instrument Name.
The name will be sent with the DHCP request and will be
used to update the DNS settings. This name would allow
you to assign an Instrument Name such as "My_Rf." Users
would then access the instrument through the address
"http://My_Rf."
4. Click the OK button to save the settings.
5. Confirm that your network administrator has completed
any necessary network changes to support the system.
6. Locate the CAT5 connection cable (P/N 480-6545-01) in the
accessory package. Insert one end into the Ethernet port on
the back panel. Connect the other end of the cable to your
network access port.
You should be able to connect to the CombiFlash R
on the network (Section 4.1.1) and set up a network printer
(Section 4.1.2).
4.1.1 Network PC Access
A successfully networked CombiFlash R
accessed by a PC that meets the recommendations listed in
Table 4-1.
To access the system simply open an Internet Browser and
enter the correct address.
4-2
from a PC
f
system can be
f
Advertisement
Table of Contents
