Table of Contents
Advertisement
"5: ITF":
Minimum number of digits to be read for ITF
"6: CODABAR": Minimum number of digits to be read for Codabar
Set minimum number of digits for the Code to be read.
Press [ ] to decrease the setting value and [ ] to increase the setting value.
ITF entry range:
Codabar entry range:
Setting a small number of digits increases the frequency of missing digits when reading or incorrectly
reading depending on how codes are read or the quality of codes.
On the other hand, setting a large number will decrease the possibility of such errors.
"2:DEVICE SETTINGS": Device settings during reading
1.
Use the cursor keys ([▲] [▼]) or numerical keys ([1] [2] [3] [4] [5]) to highlight
the item to be set, highlight the setting value using the cursor keys ([◄] [►])
and press the ENT key.
Press the C key to return to the SET CODE SCANNING CONDITIONS
menu.
"1: SCAN MODE"
Set the scan mode.
"0": Normal mode
Codes within the field of view can be read.
Refer to "Chapter 8 Specifications" regarding the size of the field of view.
"1": Point scan mode
Codes above the cross at the center of the marker can be read. Reading will be unsuccessful if there is
no code above the cross or the marker cannot be detected due to external light. This kind of reading is
only enabled if marker illumination is enabled.
"2: MARKER"
Set whether the guide marker illuminates or not when the trigger switch is pressed.
"0":
Operated by trigger switch
"1":
Locked ON (Illuminates)
"2":
Locked OFF (Doesn't illuminate)
When the marker is locked on, more power is used and operating times are shorter
- Point -
compared to other modes. Do not change these settings unless necessary.
2 - 20
(default: 4)
3 - 20
(default: 4)
2D Code Handy Terminal
1
69
Advertisement
Chapters
Table of Contents
