Table of Contents
Advertisement
BHT-604Q
"3: LIGHT"
Set whether the INDICATOR LED light illuminates or not when the trigger switch is depressed.
"0":
Illuminates
"1":
Illuminates
"2":
OFF
"4: SENSOR OFF TIME"
Set the sensor off time
Press [ ] to decrease the setting value and [ ] to increase the setting value.
OFF time setting range: 0～255
"5: SENSOR OFF TIME 2"
Set the time from close to sensor off
Press [ ] to decrease the setting value and [ ] to increase the setting value.
OFF time setting range: 0～255
[5] Setting the communication environment
The communication environment settings following system initialization are follows.
Do not change these settings unless necessary.
Interface used
Communication protocol type
Infrared interface port
TRANSMIT SPEED
PROTOCOL
Connector interface port
TRANSMIT SPEED
PARITY BIT
DATA BIT
STOP BIT
PROTOCOL
70
Default value : 255
Default value : 0
Item
Baud rate
Protocol options
Baud rate
(Vertical parity)
(Character
length)
(Stop bit length)
(Protocol options)
Default
Optical (infrared interface port)
Ymodem protocol
115200 Bps
SERIAL No.:
ON (
Adds serial numbers to data
)
blocks.
H. PARITY:
ON (Adds horizontal parity.)
LINKUP TIME:
30 seconds
FIELD SPACE:
ignore (Trim)
115200 Bps
None
8 bits
1 Bit
SERIAL No.:
ON (
Adds serial numbers to data
blocks.
)
H. PARITY:
ON (Adds horizontal parity.)
LINKUP TIME:
30 seconds
FIELD SPACE:
ignore (Trim)
Advertisement
Chapters
Table of Contents
