Denso BHT-604Q User Manual page 104

BHT-604Q
"BATCH": Batch edit mode
The data is stored in memory when all segmented codes within the reading field of view have been
read.
"NONE": Unedited mode
The data is stored in memory each time a segmented code is read.
In edit mode, when the first code of the concatenated code is read the beeper sounds twice and the
system enters concatenated code reading status.
When subsequent concatenated codes are read the beeper sounds once. After the final code has
been read, the beeper sounds three times and reading is complete.
To change the setting, use the cursor keys ([▲] [▼]) or numerical keys ([1][2][3][4]) to highlight the item to
be set, highlight the setting value using the cursor keys ([◄] [►]), and then press the ENT key.
Press the [C] key to return to the detailed settings screen for the code reading test.

- Point -


"2: DATAMATRIX": Selecting enable/disable DATAMATRIX reading
"1: SQUARE":
Enable/disable SQUARE DATAMATRIX.
"2: RECTANGULAR":
Enable/disable RECTANGULAR DATAMATRIX.
To change the setting, use the cursor keys ([▲] [▼]) or numerical keys
([1][2]) to highlight the item to be set, highlight the setting value using the
cursor keys ([◄] [►]), and then press the ENT key.
Press the [C] key to return to the detailed settings screen for the code
reading test.
92
If QR codes other than concatenated codes are read during concatenated code reading
then concatenated code reading ends, the read concatenated codes are discarded, and
the data for the last QR codes read is saved.
When the illuminating indicator LED is set to OFF in trigger switch operation (Auto-off
mode, Momentary mode, and alternate) or when the reading of the next concatenated code
is not completed within approx. 3 seconds in modes other than Auto-off mode, the data
read so far is cleared and concatenated code reading ends.
When other concatenated codes are read before a concatenated code has been read
completely, the data read so far is cleared and reading begins on the new code.