Parameter Tables Of The Tool Data - Siemens SINUMERIK 802D Programming And Operating Manual

Appendix
A.2 Parameter tables of the tool data
A.2

Parameter tables of the tool data

The following parameters, operated from the HMI, are available for the tool offsets.
Table A- 1
Tx
Tx
Tx
Tx
Tx
Tx
Tx
Tx
Tx
Tx
Tx
Tx
Tx
Tx
Tx
Tx
Tx
Tx
Tx
Table A- 2
Tx Dy
Tx Dy
Tx Dy
Tx Dy
Tx Dy
Tx Dy
Tx Dy
Tx Dy
Tx Dy
Tx Dy
Tx Dy
Tx Dy
Tx Dy
Tx Dy
Tx Dy
380
Grinding wheel data, x=[1...n] y=[1...6]
TPG1 INT
TPG2 INT
TPG3 REAL
TPG4 REAL
TPG5 REAL
TPG6 REAL
TPG7 REAL
TPG8 REAL
TPG9 INT
TPC1 REAL
TPC2 REAL
TPC3 REAL
TPC4 REAL
TPC5 REAL
TPC6 REAL
TPC7 REAL
TPC8 REAL
TPC9 REAL
TPC10 REAL
1. Cutting edge 2. Cutting edge for left/right wheel edge for grinding wheel
DP1 INT Tool type=403
DP2 INT Cutting edge position (1...9)
DP3 REAL D - Diameter of the new wheel
DP4 REAL L - Distance of the wheel reference point
DP5 REAL (reserved, length 3)
DP6 REAL R - Tool nose radius
DP7 REAL Dressing amount (µm) left/right
DP8 REAL Dresser wear X (µm) left/right
DP9 REAL Dresser wear Z (µm) left/right
DP10 REAL Path feedrate (mm/rev), left/right
DP11 REAL Path feedrate X (mm/rev), left/right
DP12 REAL dD - Change in diameter (dressing amount X)
DP13 REAL dL - Change in distance (dressing amount Z)
DP14 REAL (Length 3)
DP15 REAL dR - Change in tool nose radius (radius wear)
Spindle number
Concatenation rule = 0
Min. wheel diameter
Min. wheel width
Current grinding wheel width
Maximum speed
Maximum GWPS
Angle of inclined wheel
Parameter no. for radius calculation
Wheel type (vertical, inclined, free)
Amount of crown
Dressing amount
Cylindric compensation
GWPS
GWPS ratio
Bypassing strategy (obstacle diameter)
Basic cutting edge for dressing contour
X shift
Z shift
Programming and Operating Manual, 07/2009, 6FC5398-4CP10-2BA0
Cylindrical grinding