Siemens SINUMERIK 802D Programming And Operating Manual page 42

Define
4.2 Create new tool
Geometry data
This function is used the enter the wheel geometry for the wheel type selected.
Figure 4-7
The following wheel types are available:
● Vertical wheel without back-slopes (type 1)
● Vertical wheel with back-slopes (type 2)
● Left-hand side inclined wheel (type 3)
● Right-hand side inclined wheel (type 4)
● Free contour (type 0)
The input screen is self-explaining.
Note
A red dot shown in the diagrammatic sketch indicates the geometry value just being entered.
42
Geometry example data for a vertical wheel with back-slope
Programming and Operating Manual, 07/2009, 6FC5398-4CP10-2BA0
Cylindrical grinding