Reciprocating - Cycle415 - Siemens SINUMERIK 802D Programming And Operating Manual

Cycles
9.13 Reciprocating – CYCLE415
9.13 Reciprocating – CYCLE415
Programming
CYCLE415(N_SITZ, X_SOLL, Z_ST, Z_END, B_ART, A_LU, A_SR, A_SL, A_FSL, SRZ,
SLZ, FSLZ, ZU_ART, BVU1, BVU2, F_PE, FP_SL, FP_FS F_SR, F_SL, F_FSL, N_FR, MZ,
KS, F_KS, UWERK)
Parameter
Table 9- 10
Parameter
N_SITZ
X_SOLL
Z_ST
Z_END
B_ART
A_LU
A_SR
A_SL
A_FSL
SRZ
SLZ
FSLZ
ZU_ART
BVU1
BVU2
F_PE
FP_SL
FP_FS
F_SR
F_SL
F_FSL
N_FR
MZ
KS
F_KS
UWERK
194
Parameters of CYCLE415
Data type Meaning
INT Seat number
REAL Setpoint diameter (abs.)
REAL Starting position in Z (abs.)
REAL Target position in Z (abs.)
INT Machining type:
1=roughing
2=finishing+fine-finishing
3=roughing+finishing+fine-finishing
REAL Air allowance (incr.)
REAL Roughing allowance (incr.)
REAL Finishing allowance (incr.)
REAL Fine-finishing allowance (incr.)
REAL Infeed amount for roughing (incr.)
REAL Infeed amount for finishing (incr.)
REAL Infeed amount for fine-finishing (incr.)
INT Infeed
-1 = only on the left
0 = on both sides
1 = only on the right
INT Dwell time at reversal point1
INT Dwell time at reversal point2
REAL Reciprocation feedrate for roughing
REAL Reciprocation feedrate for finishing
REAL Reciprocation feedrate for fine-finishing
REAL Feedrate for roughing
REAL Feedrate for finishing
REAL Feedrate for fine-finishing
INT Number of sparking-out strokes
INT Measurement control Y=1 / N=0
INT Acoustic emission sensor Y=1/N=0
REAL Feedrate for air grinding [mm/min]
REAL Workpiece peripheral speed [m/min]
Programming and Operating Manual, 07/2009, 6FC5398-4CP10-2BA0
Cylindrical grinding