Siemens SINUMERIK 802D Programming And Operating Manual page 384

Appendix
A.2 Parameter tables of the tool data
Tx Dy
Tx Dy
Tx Dy
Tx Dy
Tx Dy
Tx Dy
Tx Dy
Tx Dy
Tx Dy
Tx Dy
In addition to the default coding of the tool data (tool type, cutting edge position, etc.), the
following coded parameters are used.
Encoding
0
1
2
3
4
5
Encoding
0
1
2
11
12
21
22
Encoding
0
1
...
11
12
21
384
DPC1 REAL Reciprocation speed
DPC2 REAL Dressing amount
DPC3 REAL Approaching distance
DPC4 REAL X start
DPC5 REAL Z start
DPC6 REAL Dresser type (0 – X/Z, >0 rear, rotating,...)
DPC7 REAL Profile depth
DPC8 REAL Safety speed
DPC9 REAL X oscillating path
DPC10 REAL Reserved
Wheel type $TC_TPC1[T]
free contour
Standard contour straight without rear definitions
Standard contour straight with rear definitions
Standard contour inclined left
Standard contour inclined right
Standard contour straight profile roller with geo axes
Dressing mode at the diameter $TC_DP19[T,1]
neither drawing nor plunging (3rd dresser)
drawing (last active dresser)
plunging (last active dresser)
drawing (1st dresser)
plunging (1st dresser)
drawing (2nd dresser)
plunging (2nd dresser)
Dresser type $TC_DPC6[T,_GC_DNUM+dresser-1]
Dresser geometry axes (diamond) non-rotating
Dresser geometry axes (diamond) non-rotating
Dresser, geometry axes (form roll) rotating
Dresser, geometry axes (form roll) rotating
Dresser, geometry axes (diamond) rotating
Programming and Operating Manual, 07/2009, 6FC5398-4CP10-2BA0
Cylindrical grinding