Siemens SINUMERIK 802D Programming And Operating Manual page 148

System
8.6 SYSTEM - "Start-up files" softkeys
Interface parameters
Table 8- 8
Parameter
Device type
Baud rate
Stop bits
Parity
Data bits
Overwriting
with
confirmation
Reading-in and reading-out data of the manufacturer's directory "F".
Reading-in and reading-out data of a USB FlashDrive.
148
Interface parameters
Description
RTS CTS
The signal RTS (Request to Send) controls the send mode of the data transfer
device.
The CTS signal indicates the readiness to transmit data as the acknowledgment
signal for RTS.
... used to set the interface transmission rate.
300 baud
600 baud
1200 baud
2400 baud
4800 baud
9600 baud
19200 baud
38400 baud
57600 baud
115200 baud
Number of stop bits with asynchronous transmission
Input:
1 stop bit (default setting)
2 stop bits
Parity bits are used for error detection. These are added to the coded character to
convert the number of digits set to "1" into an odd or even number.
Input:
No parity (default setting)
Even parity
Odd parity
Number of data bits with asynchronous transmission
Input:
7 data bits
8 data bits (default)
Y: When reading in, it is checked whether the file already exists in the NC.
N: The files are overwritten without confirmation warning.
Programming and Operating Manual, 07/2009, 6FC5398-4CP10-2BA0
Cylindrical grinding