Repositioning After Interruption - Siemens SINUMERIK 802D Programming And Operating Manual

Automatic mode

6.8 Repositioning after interruption

6.8 Repositioning after interruption
After interrupting the program (<NC STOP>), you can retract the tool from the contour in
manual mode (JOG). The control saves the coordinates of the point of interruption. The
distances traversed are displayed.
Operating sequence
Select <AUTOMATIC> mode.
Press <NC START> to continue machining.
When reapproaching the interruption point, all axes will traverse at the same time. Make
sure that the traversing area is not obstructed.
94
CAUTION
Programming and Operating Manual, 07/2009, 6FC5398-4CP10-2BA0
Cylindrical grinding