Cycles
9.4 Zyklenunterstützung im Programmeditor
Operating the cycle support
Figure 9-2
To add a cycle call to the program, carry out the following steps one after the other:
● You can use the "Grinding cycles" softkey in the horizontal softkey bar to access
● The cycle selection is carried out using the vertical softkey bar until the appropriate input
● Number values can be directly entered. Entered values are verified for proper range.
● Some parameters that may have only a few values are selected using the toggle key.
● Press "OK" to complete your input (or "Abort" in case of error).
162
Menu tree for cycle support
selection bars for the individual cycles.
screenform with the help display appears on the screen.
Programming and Operating Manual, 07/2009, 6FC5398-4CP10-2BA0
Cylindrical grinding