Siemens SINUMERIK 802D Programming And Operating Manual page 53

The values for the setting value (position in Z axis), feedrate, and approach direction are
entered into the input screen.
Press the "Set position" softkey to set up the measuring position.
The Z axis feeds in probe direction until the workpiece is touched. This position is set as a
value and the probe retracts.
After a confirmation, the X axis traverses to its retract position and the probe swings out.
The positions determined are taken into account in CYCLE420 if longitudinal alignment has
been enabled. For this, the X measuring position is approached and the Z position can be
selected within the cycle.
Note
Both calibration and measurement must always be done in the same direction.
The function can be interrupted.
Exit the function.
Cylindrical grinding
Programming and Operating Manual, 07/2009, 6FC5398-4CP10-2BA0
Define
4.6 Sense probe
53