Body Panels - Arctic Cat 2016 Wildcat Sport Service Manual

INSTALLING GRILLE
Place the grille into position and secure it using the exist-
ing cap screws. Tighten all hardware to 60 in.-lb.

Body Panels

REMOVING REAR BODY PANELS
1. Remove the seats.
2. Remove the push pins and cap screws securing the
rear fenders.
WS049A
! WARNING
The heat deflector under the right-rear fender has sharp
edges and can cause serious injury if care is not taken.
3. Remove the cap screws securing the taillight/brake-
light assembly to the frame and disconnect the har-
ness.
WS036A
WT222
18
4. Remove the fasteners securing the right rear body
panel.
WT241A
WS050A
5. Loosen the gas tank filler hose clamp and slide it
down towards the tank.
WT244
6. Remove the panel from the frame while also pulling
on the filler hose. Seal off the hose to prevent objects
from entering the hose.
WT246