Arctic Cat 2016 Wildcat Sport Service Manual page 153

WT514A
WT512
3. Remove the two banjo bolts securing the banjo fit-
tings to the master cylinder. Discard the four crush
washers.
WT511A
CAUTION
Brake fluid is highly corrosive. Do not spill brake fluid
on any surface of the vehicle.
4. Remove the two cap screws securing the master cyl-
inder to the frame.
152
WT513A
INSPECTING
1. Inspect the master cylinder push rod and clevis for
wear, bending, or elongation of clevis holes.
2. Inspect the push rod boot for tears or deterioration.
3. Inspect the reservoir for cracks and leakage.
4. Inspect the brake hose for cracks and deterioration
and the condition of the banjo-fittings.
INSTALLING
1. Place the master cylinder into position and secure
with cap screws. Tighten to 25 ft-lb.
WT513A
2. Install the pivot pin and secure with a new cotter pin;
then connect the switch.
3. Using four new crush washers installed on both sides
of the banjo fitting, secure the banjo bolts into the
master cylinder. Tighten to 20 ft-lb.
WT511A
4. Fill the master cylinder and bleed the brake system
(see Hydraulic Brake System in Periodic Mainte-
nance/Tune-Up).