Bottom-Side Components; Removing Bottom-Side Components - Arctic Cat 2016 Wildcat Sport Service Manual

NOTE: Applying a small bead of silicone between

the head cover and rubber gasket will aid in assem-
bling.
24. Tighten the head cover fasteners in the order shown
to 7 ft-lb with the rubber washers and steel cups.
WT163A
25. Install the cam timing sensor with O-ring (lightly
coated with grease).
WT165
26. Install the timing inspection and magneto plugs.
Tighten the timing inspection plug to 10 ft-lb and the
magneto plug to 8 ft-lb.
WT166A
27. Install the starter motor and secure with the two cap
screws.
60
ROV1-116A
28. Install the thermostat housing.
NOTE: Apply a small amount of grease to the

O-ring before installing.
WT168

Bottom-Side Components

NOTE: For efficiency, it is preferable to remove and

disassemble only those components which need to be
addressed and to service only those components. The
technician should use discretion and sound judgment.
AT THIS POINT

To service any one specific component, only limited dis-
assembly of components may be necessary. Note the
AT THIS POINT information in each sub-section.
 NOTE: The engine must be removed from the frame
for this procedure.
Removing Bottom-Side
Components
1. Remove the cap screws securing the PTO-side cover
to crankcase.