Steering System - Arctic Cat 2016 Wildcat Sport Service Manual

2. Install the hairpin clip on the steering shaft.
WT297
NOTE: If the hole in the steering shaft does not

align with the slots in the nut, tighten the nut slightly
until the next slot aligns with the hole.

Steering System

 NOTE: Thoroughly troubleshoot the EPS prior to
replacing the EPS assembly (see Electrical System) as
there are several possible external causes for system
failure.
REMOVING EPS
NOTE: Before removing the EPS assembly, ensure

the front wheels are aligned to the front.
1. Remove the steering wheel, hood, and dash.
2. Remove the cap screws and discard the lock nuts
securing the upper steering shaft to the frame.
WT607A
3. Unplug the electrical connections (A); then remove
the cap screw and discard the lock nut (B).
24
WT608A.
4. Remove upper steering shaft; then remove the cap
screws securing the EPS assembly to the frame and
steering shaft. Discard lock nut.
WT604A
WT604B
5. Remove the EPS assembly from the vehicle.
NOTE: The EPS is a non-serviceable component; it

must be replaced as an assembly.
INSTALLING EPS
1. Place the EPS assembly into position being sure to
align the timing mark of the EPS assembly with the
opening of the steering shaft. Secure with cap screws
but do not tighten at this point.