Arctic Cat 2016 Wildcat Sport Service Manual page 130

TA012A
3. Remove and discard the lock nut securing the bell
crank; then using two screwdrivers, pry the bell
crank off the shift shaft.
TA012B
TA027
4. Remove the clip securing the gear position switch.
Gently pry the switch off the shift rail and account
for the wave washer.
5. Remove the screws securing the case halves together.
6. While prying the two halves apart with an assistant,
use a rubber mallet to gently tap the shift shaft (A),
shift drum (B), and output shaft (C) into the lower
half.
TA131A
 NOTE: Use a suitable bearing seal protection tool
and when driving the bearing and gears into the lower
half of the transaxle.
7. Clean any silicone residue from the case halves.
DISASSEMBLING HALVES
1. Remove the shift shaft assembly and the detent.
TA006A
2. Remove the park pawl with dowel pin and account
for the spring.
TA028A
3. Remove the output gear assembly with bearings.
129