Lcd Gauge; Front Rack; Front Bumper Assembly; Front Body Panel/Side Panels - Arctic Cat 2014 400 TRV Service Manual

LCD Gauge

REPLACING
To replace the gauge, use the following procedure.
1. Remove the two reinstallable rivets securing the
instrument pod; then remove the ignition switch
retaining ring.
2. Remove the two nuts securing the mounting studs;
then remove the gauge and disconnect the
multi-pin connector.
3. Mount the gauge and secure with the two nuts;
then connect the multi-pin connector.
4. Install the instrument pod and secure with the rein-
stallable rivets.
5. Secure the ignition switch with the retaining ring.

Front Rack

REMOVING
1. Remove the cap screws and lock nuts securing the
rack to the frame and front fender panel.
2. Remove the front rack from the ATV.
CLEANING AND INSPECTING
1. Clean all rack components using a pressure washer.
2. Inspect all welds for cracking or bending.
3. Inspect threaded areas of all mounting bosses for
stripping.
4. Inspect for missing decals and/or reflectors.
INSTALLING
1. Place the rack into position on the frame and front
fender panel. Install the cap screws and lock nuts and
finger-tighten only.
2. Install the two cap screws and lock nuts securing the
rack to the fenders. Tighten all hardware securely.

Front Bumper Assembly

REMOVING
1. Remove the two flange bolts and lock nuts securing
the upper bumper supports to the bumper.
2. Remove the through-bolt and lock nut securing the
bumper to the frame; then remove the bumper.
18
CLEANING AND INSPECTING
1. Clean all bumper components with parts-cleaning
solvent.
2. Inspect all welds for cracking or bending.
INSTALLING
1. Place the front bumper assembly into position and
install the through-bolt. Start the lock nut and fin-
ger-tighten only.
2. Install the two flange bolts and lock nuts on the
upper supports. Tighten all hardware securely.
Front Body Panel/Side
Panels
REMOVING
1. Remove the reinstallable rivets securing the radiator
access cover and remove the cover; then remove four
reinstallable rivets securing the steering post cover
and remove the cover.
2. Unlock the storage compartment lid; then slide the
storage compartment cover assembly forward and
lift off the storage compartment.
3. Remove the storage compartment box; then remove
the seat.
4. Remove the ignition switch retaining ring and two
reinstallable rivets securing the instrument pod; then
remove the instrument pod.
5. Remove the cap screws and lock nuts securing the
front rack to the frame; then remove the front rack.
Account for the grommets and bushings.
6. Remove the side panels by pulling on them to release
the tabs from the body; then remove the screws
securing the rear of the front panel to the frame.
CF237A