Arctic Cat 2016 Wildcat Sport Service Manual page 62

ROV1-045A
2. Using an appropriate puller if needed, remove the
PTO-side cover. Account for a gasket, two dowel
pins, and two longer fasteners for assembly pur-
poses.
ROV1-048
3. Remove the chain by pulling it down through the
crankcase and out the PTO side.
4. Remove the fastener securing the chain guide to the
crankcase.
ROV1-056A
NOTE: If the water pump does not require servic-

ing, it does not need to be removed.
5. Remove the cap screws securing the water pump
cover to the crankcase. Account for two dowel pins
and an O-ring.
ROV1-054A
6. Remove the cap screws securing the MAG-side
cover to the crankcase. Account for two dowel pins
and discard the gasket.
ROV1-108A
NOTE: Account for the different-lengthed fasteners

for assembling purposes.
NOTE: If the technician's objective is to service or

replace the flywheel or starter gear, proceed to the
step 7; if not, continue to disassemble the bottom side
components without removing the flywheel or starter
gear.
7. Remove the cap screw securing the rotor/flywheel to
the crankshaft. Account for a washer and install the
crankshaft protector.
KC545
8. Using the flywheel puller, remove the flywheel.
61