Related Drive Parameters - YASKAWA v1000 Installation Manual

6 Related Drive Parameters

6 Related Drive Parameters
The following parameters are used to set up the drive for operation with the option. Parameter
setting instructions can be found in the drive manual.
Confirm proper setting of the parameters in
After changing parameter settings, cycle power to the drive for the new settings to take effect.
No.
(Addr. Name
Hex)
b1-01
Frequency Reference
(0180)
Selection 1
<1>
b1-02
Run Command
(0181)
Selection 1
<1>
F6-01 Communications Error
(03A2) Operation Selection
External Fault from
F6-02
Comm. Option
(03A3)
Detection Selection
External Fault from
F6-03
Comm. Option
(03A4)
Operation Selection
Multi-Step Speed
F6-07 Enable/Disable
(03A8) Selection when NefRef/
ComRef is Selected
F6-08
Reset Communication
(036A)
Parameters
<3>
F6-14
bUS Error Auto Reset
(03BB)
30
Table 7 Related Parameters
0: Digital operator
1: Analog input terminals
2: MEMOBUS/Modbus communications
3: Option PCB
4: Pulse input (terminal RP)
0: Digital operator
1: Digital input terminals
2: MEMOBUS/Modbus communications
3: Option PCB
0: Ramp to stop. Decelerate to stop using the deceleration
time in C1-02.
1: Coast to stop
2: Fast Stop. Decelerate to stop using the deceleration time
in C1-09.
3: Alarm only
1: Detection during run only
0: Ramp to stop. Decelerate to stop using the deceleration
time in C1-02.
1: Coast to stop
2: Fast Stop. Decelerate to stop using the deceleration time
in C1-09.
3: Alarm only
0: Multi-step reference disabled (same as F7)
1: Multi-step reference enabled (same as V7)
0: Communication-related parameters (F6-oo/F7-oo)
are not reset when the drive is initialized using A1-03.
1: Reset all communication-related parameters
(F6-oo/F7-oo) when the drive is initialized using
A1-03.
0: Disabled
1: Enabled
YASKAWA TOEP YAICOM 15A V1000 Option Dual-Port EtherNet/IP SI-EN3D/V Installation Manual
Table 7 before starting network communications.
Description
<2>
<2>
Values
Default: 1
Range: 0 to 4
Default: 1
Range: 0 to 3
Default: 1
Range: 0 to 3
Default: 0
Range: 0, 1
Default: 1
Range: 0 to 3
Default: 1
Range: 0, 1
Default: 0
Range: 0, 1
Default: 0
Range: 0, 1