YASKAWA v1000 Installation Manual page 48

12 Troubleshooting
Error
Code Description
(Hex)
08 Service not supported
09 Invalid attribute value
0C Object state conflict
0E Attribute not settable
13 Not enough data
15 Too much data
16 Object does not exist
1F Vendor-specific error
20 Invalid parameter
Note: Refer to the MEMOBUS/Modbus Data Table in the MEMOBUS/Modbus Communications chapter of
the drive manual for a list of monitor data using the MEMOBUS/Modbus message area.
u
Option Error Codes
n Option Fault Monitors U6-98 and U6-99
The option can declare error/warning conditions via drive monitor parameters on the drive
digital operator as shown in
Fault
Condition
No Fault
Force Fault
Network Link
Down
Connection
Timeout
Duplicate IP
Address
48
Table 10 Communications Errors and Solutions
The service code is incorrect.
The attribute is incorrect.
Attempted to change a drive constant that
cannot be changed while the drive is
running.
Attempted to change a read-only attribute. Correct the service code or attribute setting.
The data size is incorrect.
The data size is incorrect.
An unsupported object was specified.
Attempted to change a drive constant that
cannot be changed while the drive is
running.
Attempted to change a drive constant to a
value outside the setting range.
Attempted to change to a data value outside
the setting range.
Table 11.
Table 11 Option Fault Monitor Descriptions
Fault Declared
n/a
EF0
BUS ERROR
BUS ERROR
BUS ERROR
YASKAWA TOEP YAICOM 15A V1000 Option Dual-Port EtherNet/IP SI-EN3D/V Installation Manual
Cause
Status Value
(U6-98/U6-99)
0 No faults
Network sent a message to force this node
3
to the fault state.
1100 No network link to option.
The node timer (Requested Packet
1101
Interval) timed out.
This node and at least one other node have
1102
the same IP Address.
Possible Solution
Correct the service code.
Correct the attribute.
Stop the drive.
Correct the data size.
Correct the data size.
Correct the class or instance setting.
Stop the drive.
Specify a value within the setting range.
Specify a data value within the setting
range.
Description