Alcatel-Lucent 1665 Installation Manual page 193

Installation tests
............................................................................................................................................................................................................................................................
Note:
loopback at the DSX-3 on all ports. If loopbacks are used, make sure to take down any
cross-connections.
........................................................................................................................................................................................................................
12
If there are still FAULT LEDs on, replace the respective circuit pack.
........................................................................................................................................................................................................................
13
Disconnect the office alarm cable until all procedures and testing have been completed.
........................................................................................................................................................................................................................
14
Check off the appropriate box in
E O
N D
........................................................................................................................................................
............................................................................................................................................................................................................................................................
365-372-304R7.1
Issue 2 March 2008
LNW16 (DS3/EC1) circuit pack require either a 75-ohm termination or a
S
F T E P S
Appendix E, "Installation
Clearing alarms
checklist".
4 - 9