Sync Cable With Molded Db9 Connector Installation - Alcatel-Lucent 1665 Installation Manual

Equipment and cable installation
............................................................................................................................................................................................................................................................
Figure 1-23 Sync cable with molded DB9 connector installation
........................................................................................................................................................................................................................
2
Route the cable to proper location and cut to desired length.
........................................................................................................................................................................................................................
3
Terminate the wires in the red jacket for an output signal.
........................................................................................................................................................................................................................
4
Terminate the wires in the gray jacket for an input signal.
........................................................................................................................................................................................................................
5
Repeat
............................................................................................................................................................................................................................................................
365-372-304R7.1
Issue 2 March 2008
TO DS1 SYNCHRONOUS TIMING REFERENCE
Step 1 through Step 4
CABLE TIE (TYPICAL)
TIE CABLE ASSY'S TO CABLE SUPPORT BAR
(AS REQUIRED)
to connect the Sync cable to the SYNC2 (J14) port.
Sync cable installation
1 - 7 3