Alcatel-Lucent 1665 Installation Manual page 32

Equipment and cable installation
............................................................................................................................................................................................................................................................
Quantity
1
1
1
* Registered trademark of Thomas & Betts Corporation
† Registered trademark of Paladin Corporation.
Mounting options
The mounting brackets on the Alcatel-Lucent 1665 DMX High-Capacity shelf are
designed to allow for mounting in the following:
Standard 23-inch wide network bay frames
•
The recommended network bay frames are the ED-8C500 and the ED-8C501 (rear
access only). Refer to
shelf bay mounting arrangements" (p. 1-12)
network bay frame.
Seismic 23-inch network bay frame
•
The ED-8C800-500 and ED-8C801-501 seismic network bay frames are designed for
use in all earthquake zones, and in general, do not require top support at the 7-foot
level. These frames meet Pacific Bell Equipment Framework Standard PBS-000-
102PT.
19-inch bay frames
•
23-inch wide EIA-Type bay frames
•
1665 DMX added to the 1675 LambdaUnite
In order for the Alcatel-Lucent 1665 DMX shelf to be placed in a NEBS-2000 Cabinet
frame combined with Alcatel-Lucent 1675 LambdaUnite
is required. For a more complete view of mounting the Alcatel-Lucent 1665 DMX into the
Alcatel-Lucent 1675 LambdaUnite
DMX added to the Alcatel-Lucent 1675 LambdaUnite
Cabling checklist
This section briefly describes cabling information. For information regarding available
cable lengths and ordering comcodes, refer to ED8C871-10.
............................................................................................................................................................................................................................................................
1 - 4
Description
Torque Wrench
ITE-5952
Ohmmeter ITE-6379
SPG800
Figure 1-4, "Typical Alcatel-Lucent 1665 DMX High-Capacity
®
MultiService Switch (MSS) configurations
®
Comments
A torque wrench (50-250 IN-LBS) is used when
tightening the Alcatel-Lucent 1665 DMX High-
Capacity shelf to the frame. It is also used when
reattaching the mounting brackets to the Alcatel-
Lucent 1665 DMX High-Capacity shelf.
An ohmmeter is required to verify that the Alcatel-
Lucent 1665 DMX is properly grounded.
Electric Continuity Test Tool LNW94 TESTPK (for
DS1/DS3/Ethernet Cabling)
for 1665 DMX shelf placement in a
®
Frame, see SIG-L-WW-161A, Alcatel-Lucent 1665
®
MSS Configurations.
MSS, mounting kit 848856514
365-372-304R7.1
Issue 2 March 2008
Planning