Removing Pci Add-In Cards; Figure 42. Installing Pci Add-In Card - Intel SC5650SCWS Service Manual

6. Remove a PCI add-in board from its protective wrapper. Be careful not to touch the components or gold-edge connectors.
Place the board on an anti-static surface. Record the type and serial number of the add-in board in your equipment log. Set
jumpers or switches on the board according to the manufacturer's instructions.
7. Hold the PCI add-in board by its top edge or upper corners. Firmly press the add-in board into an expansion slot on the
workstation board (see letter "A" in the following figure). Close the back panel PCI Add-in Card Retention Device (see letter
"B").
8. Repeat the previous steps until all PCI add-in boards are installed.
9. Attach cables, if necessary.
10. Reinstall the left side cover. For instructions, see
11. Reconnect all peripheral devices and the AC power cable. Power up the Workstation.

Removing PCI Add-in Cards

CAUTIONS
PCI add-in boards can be extremely sensitive to electric static discharge (ESD) and always require careful handling. After
removing the add-in board from its protective wrapper or from the workstation board, place it component side up on a
grounded, static-free surface or conductive foam pad. Do not slide the add-in board over any surface.
1. Observe the safety and ESD precautions listed in Appendix A,
2. Power down the workstation and unplug all peripheral devices and the AC power cable.
3. Remove the left side cover. For instructions, see
4. Open the back panel PCI Add-in Card Retention Device by pressing open from the inside of the chassis.
Intel® Workstation System SC5650SCWS Service Guide

Figure 42. Installing PCI Add-in Card

"Installing the Left Side Cover".
"Removing the Left Side Cover"
Hardware Installations and Upgrades
"Safety Information".
47