Removing A Fixed Hard Drive - Intel SC5650SCWS Service Manual

Hardware Installations and Upgrades
14. Re-attach the drive cage EMI shield to the chassis and tighten the thumb screw.
15. Re-install any PCI add-in cards that were removed. For instructions, see "Installing PCI Add-in Boards".
16. Re-install the front bezel assembly. For instructions, see "Installing the Front Bezel Assembly".
17. Re-install the left side cover. For instructions, see "Installing the Left Side Cover".
18. Plug all peripheral devices and the AC power cable back into the workstation. Power up the workstation.

Removing a Fixed Hard Drive

CAUTIONS
Fixed drives are NOT hot-swappable. Before removing or replacing the drive, you must first take the
workstation out of service, turn off all peripheral devices connected to the system, turn off the system
by pressing the power button, and unplug the AC power cord from the system or wall outlet.
1. Observe the safety and ESD precautions listed in Appendix A,
2. Power down the workstation and unplug all peripheral devices and the AC power cable.
3. Remove the left side cover. For instructions, see
4. Remove the front bezel assembly. For instructions, see
Assembly".
5. Loosen thumb screw (see letter "A" in the following figure). Apply slight pressure to the right side of drive
bay access door and swing door outward (see letter "B").
Intel® Workstation System SC5650SCWS Service Guide
Figure 58. Re-installing Drive Cage EMI Shield
"Removing the Left Side
"Removing and Installing the Front Bezel
"Safety Information".
Cover".
56