Intel SC5650SCWS Service Manual page 16

Workstation System Features
Feature
Cooling
Processors
Memory
Chipset
Add-in card slots
Video Support
USB drive support
I/O control support
Intel® Workstation System SC5650SCWS Service Guide
Description
Two 120-mm system fans (rear fan and PCI zone)
One 92-mm system fans (Hard Disk Cage fan)
Active processor heat sink(s) is required
® ®
Up to two Intel Xeon Processors 5500 series with Thermal Design Power
(TDP) up to 130 W
Six memory channels (three channels per processor socket) with support for
800/1066/1333 MT/s ECC Registered (RDIMM) or ECC Unbuffered (UDIMM)
DDR3 memory
12 DIMM sockets, two DIMM sockets per channel
No mixing of RDIMMs and UDIMMs
Mixing memory type, size, speed, and/or rank on this platform has not been
validated and is not supported
Mixing memory vendors is not supported on this platform by Intel
Non-ECC memory is not supported and has not been validated in a
workstation environment
®
Intel S5520 Chipset and Intel
Two PCI Express* Gen 2 x16 slots
One PCI Express* Gen 1 slot (x4 mechanically, x1 electrically)
One PCI Express* Gen 1 slot (x8 mechanically, x4 electrically) shared with
SAS Module Slot. This PCI Express* Gen 1 slot is not available when the
SAS module slot is in use and vice versa
One 32-bit/33MHz PCI slot, keying for 5-V and universal PCI add-in card
WorkstationEngines* LLC Pilot II* with 64 MB DDR2 memory, 8 MB allocated
to graphics
Dual video is supported
On-board video available with optional accessory cable (FXXSCVDCBL)
Support add-in PCI Express* graphics cards
o
Single graphics card configuration at PCI Express* slot 6 with
graphics card up to 300W
o
Dual graphics cards conifiguration at PCI Express* slot 4 and slot 6
with each graphics card up to 150W
o
Keep PCI Express* Slot 3 empty for optimal air flow when
populating a graphics card in PCI Express* slot 4.
o
Graphics cards with power greater than 75W must be self-cooled
with exhaust out the back of the chassis
One internal USB port
One internal low-profile USB port for Solid State Drive
External connections:
o
RJ-45 serial port A connection
o
One 7.1 channel Audio connector
o
One 1394 connector for IEEE1394a support
o
One DH 10 serial port connector (optional)
o
Two RJ-45 NIC connectors for 10/100/1000 Mb connections: Dual
GbE through the Intel
I/O Acceleration Technology 2 support
o
Four USB 2.0 ports at the back of the board
Internal connections:
o
Two 9-pin USB headers, each supports two USB 2.0 ports
®
82801Jx I/O Controller Hub (ICH10R)
®
82575EB Network Connection, with Intel
®
2