Replacing The Processor; Figure 31. Install The Processor; Figure 32. Close Load Plate And Socket Lever - Intel SC5650SCWS Service Manual

Hardware Installations and Upgrades
11. Close the load plate and socket lever: Close the load plate all the way as shown in (Step "A"), push down on the load
plate (Step "B") and close the socket lever and ensure the load plate tab engages under the socket lever when fully
closed (Step "C")
12. Install the heatsink(s). See

Replacing the Processor

1. Observe the safety and ESD precautions at the beginning of this book. For more information, see
2. Turn off all peripheral devices connected to the workstation and turn off the workstation.
3. Disconnect the AC power cord from the workstation.
4. Remove the workstation's cover and fan duct, locate the processor socket.
5. If needed, disconnect the active processor heatsink fan cable from the workstation board.
6. Loosen the four captive screws on the corner of the heatsink.
7. Twist the heatsink slightly to break the seal between the heatsink and the processor.
8. Lift the heatsink from the processor. If it does not pull up easily, twist the heatsink again. Do not force the heatsink from
the processor – doing so could damage the processor.
9. Lift the processor socket lever.
10. Raise the processor socket load plate.
11. Remove the processor.
12. If installing a replacement processor, see
13. Reinstall and reconnect any parts you removed or disconnected to reach the processor sockets.
14. Replace the fan duct, hard disk cage, and chassis cover. Reconnect the AC power cord.
Intel® Workstation System SC5650SCWS Service Guide

Figure 31. Install the processor

Figure 32. Close Load Plate and Socket Lever

"Installing the Processor Heatsink(s)"
Installing the Processor
for instructions.
Safety Information.
40