Advertisement
Advertisement
Table of Contents
Related Manuals for Intel NUC Kit DC3217IYE
Summary of Contents for Intel NUC Kit DC3217IYE
-
Page 1: User Guide
Intel NUC Kit DC3217IYE User Guide Intel® NUC Kit DC3217IYE User Guide... -
Page 2: Before You Begin
If such a station is not available, you can provide some ESD protection by wearing an antistatic wrist strap and attaching it to a metal part of the computer chassis. Installation Precautions When you install and test the Intel NUC, observe all warnings and cautions in the installation instructions. To avoid injury, be careful of: ... -
Page 3: Installing And Removing Memory
1. Unscrew the four corner screws on the bottom cover of the chassis and lift the cover. Installing and Removing Memory Intel NUC Kit DC3217IYE has two 204-pin SO-DIMM sockets. Memory requirements: 1.5V DDR3 or 1.35V DDR3L (low voltage) memory ... - Page 4 7. Reinstall and reconnect any parts you removed or disconnected to reach the SO-DIMM sockets. 8. Replace the computer’s cover and reconnect the AC power cord. Installing a Mini-PCIe Wireless Adapter Only the following wireless adapters have been evaluated for regulatory compliance for use with the Intel NUC Kit DC3217IYE in all regions: ...
- Page 5 Intel NUC Kit DC3217IYE User Guide The operation of any other wireless adapter with Intel® NUC Kit DC3217IYE, other than those listed above, may violate regulatory compliance requirements for your region. For more information on wireless adapters, go to: http://www.intel.com/support/wireless/wlan.
- Page 6 Intel NUC Kit DC3217IYE User Guide 5. Secure the wireless card to the standoff with the small silver screw (C). 6. Remove the black tape holding the two wireless antennas. 7. Slide the clear plastic protective sleeve down onto the antenna wires, away from the connectors at the ends of the antennas (D).
- Page 7 Intel NUC Kit DC3217IYE User Guide Install an mSATA SSD For a list of tested mSATA drives, go to the Tested Peripherals page on the Support site. Follow these instructions to install an mSATA SSD: 1. Observe the precautions in "Before You Begin" on page 2.
-
Page 8: Close The Chassis
Intel NUC Kit DC3217IYE User Guide Close the Chassis After all components have been installed, close the Intel NUC chassis. Intel recommends this be done by hand with a screwdriver to avoid over-tightening and possibly damaging the screws. Attach and Use the VESA Bracket (Optional) Follow these instructions to attach and use the VESA mount bracket: 1. -
Page 9: Install An Operating System
Intel NUC Kit DC3217IYE User Guide 2. Attach the two slightly larger black screws to the bottom chassis cover of the Intel NUC. 3. Slide the Intel NUC onto the VESA mount bracket. Install an Operating System Refer to Supported Operating Systems for a list of Intel-validated Windows* operating systems, as well as versions of Linux that have been reported as compatible by Intel NUC owners. - Page 10 Intel NUC Kit DC3217IYE User Guide...