Output Signal Source Selection - ABB ACS 400 User Manual

Code Parameter Name
1106 2
EXT REF SELECT
Group 16
SYSTEM CONTROLS
1601
RUN ENABLE
1604
FAULT RESET SEL

Output signal source selection

It is possible to control both the relay outputs 1 and 2, as well as the analog output from serial
communication channel 1.
Relay outputs can be controlled in the following way:
Step 1: Configure the ACS 400 to supervise the value of any of the parameters 131-133 using the
parameters in group 32
Step 2: Configure a relay output 1 or 2 to respond to the status of one of the supervised
parameters.
The selected relay can now be turned on or off by writing to supervised parameter (131-133) some
value that is either above or below the given supervision limits.
Refer to Table 16 for more information on required parameter settings. With the given settings,
writing any value 100 - 255 to parameter 131
Writing any value 0 - 99 to parameter 131 causes the relay output 1 to deactivate.
Refer to Table 17 for information on analog output control.
Table 16 Relay output control.
Code Parameter Name
Group 01
OPERATING DATA
0131 1
SER LINK DATA
0132 2
SER LINK DATA
ACS 400 User's Manual
Alternative
Settings
0 =
KEYPAD
1 = 1
AI
...
8 =
COMM
9 = + 1
COMM AI
10 = * 1
COMM AI
0 =
NOT SEL
1...5 = DI1 ... DI5
6 =
COMM
0 =
KEYPAD ONLY
1...5 = DI1 ... DI5
6 = /
START STOP
7 =
COMM
.
SUPERVISION
Alternative
Settings
0 - 255
0 - 255
http://nicontrols.com
Setting for
Standard Function/Information
Modbus
8 ( ), Fieldbus reference 2 is used when EXT2
COMM
9 ( + 1) is selected as control location. See
COMM AI
or section References below for information
10 ( * 1) on the alternative settings.
COMM AI
6 ( ) The run enable signal is given through
COMM
serial communication (Control Word bit
3).
7 ( ) Fault reset is executed through serial
COMM
communication (Control Word bit 7).
1 causes the relay output 1 to activate.
SER LINK DATA
Setting for
Standard Function/Information
Modbus
- Controlling data for the relay outputs.
-
135