Led Indicators; Diagnostic Displays - ABB ACS 400 User Manual

Copy Parameters from Panel to Drive (download)
COPY TO DRIVE
Note! The drive must be stopped and in local control. Parameter 1602
set to 1 ( ).
OPEN
Selecting Full Parameter Set
Initially only the basic parameters are visible. When full Menu is active, an asterisk appears on the
second row of the panel display in Menu. Activate this function again to resume the short Menu.
AVGGTCPSUÃH@IV
0(18

LED Indicators

Red LED
OFF
OFF
ON
BLINKS

Diagnostic displays

When the red LED of the ACS-PAN-A is on or blinking, a fault is active. The relevant fault message
flashes in the panel display.
When the green LED of the ACS-PAN-A is blinking, an alarm is active. The relevant alarm
message is shown in the panel display. Alarms 1-7 arise from button operation and the green LED
does not blink for them.
The alarm and fault messages disappear when MENU, ENTER or the arrow buttons on the control
panel are pressed. The message will reappear after a few seconds if the keypad is not touched and
alarm or fault is still active.
28
0(18
LOC
Green LED
ON
BLINKS
ON
ON
http://nicontrols.com
Press & hold
8PQ`DIB
ENTER
Press & hold
AVGGTCPSUÃH@IV
ENTER
0(18
Visible if full menu is active.
Power ON and drive is operating normally.
Alarm is active.
Fault is active. Drive can be reset from the control panel.
Fault is active. Turn power off to reset the drive.
must be
PARAMETER LOCK
*
ACS 400 User's Manual