Application Macro Motor Potentiometer; Acs 400 User's Manual; Http://Nicontrols.com - ABB ACS 400 User Manual

Application Macro Motor Potentiometer

This macro provides a cost-effective interface for PLCs that vary the speed of the drive using only
digital signals.
The value of parameter 9902 is 4 (
Input signals
• Start, stop and direction
(DI1,2)
• Reference up (DI3)
• Reference down (DI4)
• Preset speed selection (DI5)
*Note!
• If both DI 3 and DI 4 are active or inactive, reference is kept stable.
• Reference is stored during stop or power down condition.
• Analog reference is not followed when motor potentiometer is selected.
Motor potentiometer parameter values:
1001 1
EXT
1002 2
EXT
1003
DIRECTION
1102 1/
EXT
1103
EXT REF
1105
EXT REF
1106
EXT REF
1201
CONST SPEED SEL
1401
RELAY OUTPUT

ACS 400 User's Manual

MOTOR POT
Output signals
• An. output AO: Frequency
• Relay output 1: Fault
• Relay output 2: Running
2 ( 1,2)
COMMANDS DI
0 (
COMMANDS NOT SEL
3 (
REQUEST
2 6 (
EXT SEL EXT
1 6 ( 3
SELECT DI U
1 60 Hz
MAX
2 0 (
SELECT KEYPAD
5 ( 5)
DI
1 3 (
FAULT

http://nicontrols.com

).
External Reference 1: 0...10 V
Reference voltage 10 VDC
Not used
Output frequency 0...20 mA <=> 0...50 Hz
+24 VDC
Start/Stop: Activate to start.
Forward/Reverse: Activate to reverse rotation direction
Reference up: Activate to increase reference*
Reference down: Activate to decrease reference*
Constant speed 1
Relay output 1, programmable
Default operation: Fault => 17 connected to 18
Relay output 2, programmable
Default operation: Running => 20 connected to 22
1402
RELAY OUTPUT
) 1503
AO CONTENT MAX
) 1601
RUN ENABLE
1) 1604
FAULT RESET SEL
,4 ) 2008
D MAXIMUM FREQ
2105
PREMAGN SEL
) 2201 /
ACC DEC
4001
PID GAIN
(-1)) 4002
PID INTEG TIME
Jumper Setting
2 2 ( )
RUN
60 Hz
0 (
NOT SEL
0 ( )
KEYPAD
60 Hz
0 (
NOT SEL
1/2 0 (
SEL NOT SEL
1.0
60 s
)
)
)
59