Canon VK-16 Setting Manual page 87

The Motion Detection Options field also allows you to set the sensitivity for motion
detection within the Active Region. There are three controls, Sensitivity, Area Ratio and
Duration.
Motion detection status can be checked by the Detection Indicator.
Detection Indicator Colors
Motion is displayed in the Detection Indicator as a green color bar and will remain green
if the level of motion is below the set Sensitivity and within a defined Area Ratio. If motion
reaches the set Sensitivity and Area Ratio, the color bar changes to yellow and if the
detected motion remains at the yellow level for the defined duration, a red color bar is
displayed and an event is triggered. The behavior of the Detection Indicator is described
as follows.
Area Ratio marker.
Area Ratio marker.
Area Ratio marker.
● Green color bar - The area of change that is less than the
specified Area Ratio, i.e., activity remains at the left of the
Area Ratio marker.
● Yellow color bar - The area of change that is equal to or greater
than the specified Area Ratio (activity peaks on or to the right
of the Area Ratio marker) but the required amount of motion
has not met the specified duration in order to trigger an event.
● Red color bar - The amount of change that meets the defined
detection conditions and motion is detected, triggering an
event, i.e., the required amount of motion has been detected
for the specified duration.
Configure Motion and Sensor Settings
Area Ratio slide bar.
Area Ratio marker.
6
87